{"id":12314,"date":"2008-01-13T13:58:10","date_gmt":"2008-01-13T13:58:10","guid":{"rendered":"http:\/\/ravenview.com\/?p=12314"},"modified":"2016-07-26T22:32:53","modified_gmt":"2016-07-26T22:32:53","slug":"woodworking-tips-tidbits-011308","status":"publish","type":"post","link":"https:\/\/ravenview.com\/woodworking-tips-tidbits-011308\/","title":{"rendered":"Woodworking Tips & Tidbits – 01\/13\/08"},"content":{"rendered":"
1. When gluing up a project it\u2019s inevitable that some of the glue will squeeze out of the joint. It\u2019s best to wait for the glue to “gel up” before scraping it off with a sharp chisel or razor blade. Wiping up the glue before it gels can spread it over the surface of the wood and cause you a lot of sanding later.<\/p>\n
2. Yellow and White glues have a shelf life of about 8-12 months after which they should be thrown away. Freezing also damages the bonding power of these glues. If the glue is excessively stringy this can also be a sign that it has passed its useful life. Glue is too inexpensive to risk building furniture with bad joints.<\/p>\n
3. When spreading glue out across a wood joint don\u2019t use your fingers! This introduces dirt and oil that may weaken the joint. A better solution is to use an old paintbrush or a small section of a hacksaw blade. Scraps of wood also serve as an inexpensive spreader.<\/p>\n
4. Have you ever had trouble driving a dowel into its hole? Quite often air and glue inside the hole can prevent the dowel from sliding in easily. To prevent this resistance you can cut a slit into the side of the dowel. This will give the air and glue a channel to escape the hole. Use your bandsaw to cut the groove in the dowel. For safety, be sure to use a clamp to hold the dowel when you cut the groove.<\/p>\n