{"id":8836,"date":"2008-03-29T07:27:07","date_gmt":"2008-03-29T11:27:07","guid":{"rendered":"http:\/\/www.woodworkersguide.com\/2008\/03\/29\/zebrawood-european-round-top-pen\/"},"modified":"2016-04-01T18:10:42","modified_gmt":"2016-04-01T18:10:42","slug":"zebrawood-european-round-top-pen","status":"publish","type":"post","link":"https:\/\/ravenview.com\/zebrawood-european-round-top-pen\/","title":{"rendered":"Zebrawood European Round Top Pen"},"content":{"rendered":"
This pen came out extremely well. I am quite pleased with it. Here are the steps that I took to create this pen. First, you will need a pen blank and a pen kit:<\/p>\n
Cut the blank to the size of the brass tubes, leaving a bit extra on both ends for the facing of the blank after the tube is glued in:<\/p>\n
Next, drill the appropriate size hole for the brass tubes. In this case I used the 7mm bit. Here you can see that I’m using the Self Centering Pen Drilling Vise<\/a>:<\/p>\n Scuff up the brass tubes with a piece of sandpaper. This is to clean off the oxidation and to give the glue a better surface to stick to:<\/p>\n Spread glue on the brass tubes and slide them into the hole in the blank with a twisting motion. Be careful not to get any glue inside the tube. You can use a number of different types of glue including epoxy and CA type glues. I use Gorilla Glue since it adheres to both metal and wood and it gives more time for seating the tube:<\/p>\n Once the glue is dried square off the ends of the blanks with a barrel trimmer. You can use a hand-held model or use one with a drill press and vise:<\/p>\n This squares the ends of the blanks and ensures a proper fit of the pen hardware:<\/p>\n Next, take the pen blanks, correct sized bushings and mandrel for the pen:<\/p>\n And put them together in the correct order, tighten the end nut making a snug fit. Do not over-tighten as this will cause the mandrel to bend:<\/p>\n Next place the mandrel on your lathe:<\/p>\n Turn the blanks round with your roughing gouge:<\/p>\n Then shape the pen to your desired shape. Once it is shaped and sanded finish it with your desired finish. For this pen I opted for the Turner’s Polish<\/a> that I recently bought. It gives a great, high-luster shine that looks extremely well on pens.<\/p>\n Once your blanks are finished its just a matter of adding the hardware that came with the kit. Exact instructions will vary depending on the kit you choose and are supplied by the manufacturer.<\/p>\n Once again, woodturning is a great way to spend a couple of hours on a snowy afternoon. \ud83d\ude42<\/p>\n Back to the shop…\n<\/p><\/div>\n","protected":false},"excerpt":{"rendered":" The mood was right to turn a pen yesterday so I turned a European Round Top Pen made out of Zebrawood. The style I chose was similar to the Spalted Birch Pen I made back in November. It is a very pleasing shape, both to look at and to hold: This pen came out extremely […]<\/p>\n","protected":false},"author":1,"featured_media":9369,"comment_status":"open","ping_status":"open","sticky":false,"template":"","format":"standard","meta":{"footnotes":""},"categories":[182],"tags":[2121,2596,1136],"yoast_head":"\n