{"id":8941,"date":"2009-07-25T06:17:16","date_gmt":"2009-07-25T10:17:16","guid":{"rendered":"http:\/\/www.woodworkersguide.com\/?p=1751"},"modified":"2016-01-25T23:35:03","modified_gmt":"2016-01-25T23:35:03","slug":"craftsman-style-end-tables-part-1","status":"publish","type":"post","link":"https:\/\/ravenview.com\/craftsman-style-end-tables-part-1\/","title":{"rendered":"Craftsman Style End Tables – Part 1"},"content":{"rendered":"
I recently finished the matching Craftsman Style End Tables that I started a few months ago. <\/p>\n
These tables are pieces two and three of a four piece set that began with the coffee table<\/a> and will also include a sofa table.<\/p>\n Building these went a lot easier than the coffee table since a lot of the steps and procedures were already developed. The only basic difference was the addition of a drawer.<\/p>\n The tables are made with the same Red Oak that I got from the salvaged church pews a couple of years ago:<\/p>\n Once all the wood was cut to size I began with the legs. Again, these were done by cutting 4 pieces to width, mitering the edges and then gluing them together with a piece of 3\/4″ square wood in the center to give a solid 2 1\/4″ square leg:<\/p>\n <\/p>\n Then it was on to the mortising. Using the Simple Plunge Router Mortising Jig<\/a> that I made last year for doing the mortises in the coffee table I made all the mortises for both end tables:<\/p>\n Obviously, the tenons were next:<\/p>\n Next, is always one of the fun parts of woodworking, the first fitting where a project begins to take shape:<\/p>\n And here they are with the side slats and drawer skirts:<\/p>\n From here it would be on to the finishing…<\/p>\n Back to the shop…<\/p>\n